LABULIT WP pipe cleaner (1 Liter)

Buy LABULIT WP Pipe Cleaner (1 liter)

Special cleaner for the pipe system of whirlpool baths and hot tubs. Small dirt particles can accumulate in the pipe system of whirlpool baths/hot tubs. These deposits often form what is known as a biofilm, which can provide additional nutrients for bacteria, germs, and Legionella bacteria. WP Pipe Cleaner mechanically removes this biofilm and cleans the whirlpool bath pipe system.

Dosage for whirlpool baths

• 125 ml per 100 l of water
• Use WP Pipe Cleaner regularly, but no later than after 8 uses or 2 months (whichever comes first)

Dosage for hot tubs

• 300–500 ml per 1,000 l of water, depending on the degree of contamination and foam formation.

Instructions for use

• The whirlpool bath/hot tub must be filled to approximately 5–10 cm above the jets.
• Make sure that the air massage is switched off.
• Now start the bubbling system.
• After approximately 10 minutes, you can switch off the bubbling function and drain the water.
• Then rinse the bath with clean water.
• If excessive foam forms during use, add 100–150 ml of LABULIT Antifoam directly to the water.